Precautions for operation of softening water equipment
This equipment is manufactured by Wenzhou Haidoneng Environmental Protection Equipment Technology Co., Ltd. It is an automatic 10-ton pure water equipment with softening reverse osmosis.
Now people have accepted this matter using softened water equipment, at the time of use may be according to his own will to pay attention to use, but we seldom notice while using the way we use is correct, even bad consequences, to shorten the service life of softened water equipment, and varying degrees of damage.
1. It is essential to keep the equipment clean daily. The refueling part should keep sufficient oil supply and pay attention not to touch the pulley during operation, so as to avoid accidents.
2. If the equipment is out of use for more than half a month, the waste water nylon pipe is raised to the exchange column, so that it does not drain until it is not used for a long time, the salt tank and the remaining salt solution in the valve body should be cleaned.And add lubricating oil to the rotating valve and the transmission parts, strictly prohibit the equipment induced, summer and mildew season shutdown more than half a month, should start the machine 60 to 120 minutes, to prevent the microorganism in the resin tank mildew.When restarting, pull the pulley by hand first, make the rotary valve rotate several times, and put the water pipe in the original position after electrifying.
3. After the equipment is in place, fix the bolts of the motor, the bolts of the limit switch and the wiring bolts inside and outside the distribution board again to avoid accidents during the operation of the equipment.The upper and lower bolts of the lever fixing block on the rotary valve should be fixed to avoid the collision of the exchange column as far as possible.
4. Do not adjust the time of the relay when the equipment is working.Then after the power supply can be broken to repair the scrubbing equipment, to fundamentally avoid the motor, switchboard, limit switch water fault.During operation, water supply and power supply should be provided at the same time. In case of shutdown, all water sources and power supply should be closed.When the user stops each time, it can not stop the machine in a short period, but should stop the machine at the same time and stop water.
0577-86864188
